You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
P
After about 4 months of work I completed the modifications to my 18 cylinder and it finally works.
I redid the 3 intake manifolds
The...
-
P
The backyard foundry hazard thing is very real, and people get in over their head sometimes and get hurt.
That is the downside to...
-
P
Lots or apocalyptic rumors going around about millions of people descending upon small rural towns, created a sort of Woodstock II...
-
P
An inexpensive alternative to resin-bound sand is sodium silicate bound sand.
Most use sodium silicate to make cores, but you can use...
-
P
I am not sure if that is a good idea :) or new. I did not find much about making gear cutters for shaper or slotting head.
A while ago...
-
P
For pieces up to 2 feet (60 cm), I use:
I took a piece of 4 inch (100 mm) schedule 40 pipe and cut it into 2 foot sections. Note...
-
Loading…
-
Loading…