Recent content by Outback Joe
Help Support Home Model Engine Machinist Forum:
-
O
Hardware Store IC Engines
Now that is very creative, and the hall sensor ignition is a nice touch. The hypodermic needle drip (I guess) carburetor seems to work well. I wonder how much tinkering it took to get it to run and it seems to run well. The description on YouTube translates to: After two years of construction...- Outback Joe
- Post #14
- Forum: Engines
-
O
Interesting Build Materials For Elbow Engine
I would love to show you a video BUT, I had to go over 100 PSI to get this to start to run and 120 PSI for a slow run. I don't want to try my luck with very sketchy materials again. I just wanted something easy and quick just to see if it could be done, yes it works but its a total failure due...- Outback Joe
- Post #3
- Forum: Engine Showcase - Finished Projects
-
O
Interesting Build Materials For Elbow Engine
Since we have been locked down here in Oregon (and going crazy)I wanted to try an Elbow Engine. But being short of the correct materials I tried something different, well very different. It runs but not as well as using the correct materials. I think I have strayed as far off the path as...- Outback Joe
- Thread
- Replies: 2
- Forum: Engine Showcase - Finished Projects
-
O
Hello everyone!
And another model builder is born, good work!- Outback Joe
- Post #12
- Forum: New Member Introductions