Recent content by Metal one

Hello Everyone Thank you all for taking the time to comment on my post- advice and information add appreciated. Question is there any advantage to the chisel point when it comes to dabbing the end. Correct me if I am wrong this design has only two cutting edges, which might make in easier to dab...

Honing stones I have available the two on the right are soft light gray one has a bit of a chewed up edge which store would be the best to dab the edge of the bit with .

Hello Everyone thank you for responding to my post appreciated I am in the early stages of drilling holes small parts for a small project in brass 24 gauge up to 1.2 mm 18 gauge not much more than that right now perhaps venture up to 1.45 mm at 15 gauge later on not sure on that. Question who...

Hello Everyone I am a novice builded have a few questions does anyone now make drill bits for the unique purpose of drilling brass ? or do all bits need to be modified first before use in order to stop the bit from grabbing the part when drilling into brass. If so who makes the best drill bits...