You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
M
Measure and correct the errors in the ports that have occurred during casting. Look at the photos that say a lot.
-
M
Hello Timo
I'm not sure if it was a question for me or for Jasonb.
My intermediate plate is clamped with the steam chest and two paper...
-
M
In the Elmers Engine that I made a plate like this is in the design. (visible sandwich) it can be only 1 or 2 mm thick.
Maybe a shallow...
-
M
I once had to increase the distance from the slide box to the cylinder a little.
I made an intermediate plate for this purpose.
This is...
-
M
Pocketing the plate keeps the outside looking the same, this is a larger engine so there was room for screws, and like many fill size...
-
M
Most of the hit & miss engines are fairly low compression. I don't have the 1/3rd scale PMD one that I built but it was possible to...
-
Loading…
-
Loading…