This is just a general question about a round column mill drill. When going from milling to drilling the length of the drill chuck is much longer than collets and requires raising the head for enough clearance. I know that this is one of the often mentioned drawbacks of a mill drill that once...
Most of us that have mill drills know what a pain not having a way to tighten the spindle can be. Here is my version of a spindle lock or rather than a lock, a way of holding the spindle while you tighten or loosen it.
You still need to use two hands to tighten the spindle, one on the wrench...
Thanks for all the responses so far.
Tin-Good point, $9 would be less than the cost of the dovetail cutter but.....making one would be a good learning experience.
mhh-great idea but unfortunately my mill does not have a tilting head. Always nice to know that there is another way to skin the cat.
Hi All, I need to make another tool holder and I don't have any dove tail cutters. I know that the angle needed is 60 degrees but I am not sure of the diameter and the width that I need to order to make the dovetail for the 100 series. Since I don't own any dovetail cutters and have never...