Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

H
Reaction score
8

Latest activity Postings About

    • H
      Harglo replied to the thread Press Fits.
      Yes I agree about measuring the shaft vs the hole. Harvey
    • H
      Harglo replied to the thread Press Fits.
      Been flowing this press fit. Try measuring the hole after you have reamed it likely its a bit larger than the stated dimension on the...
    • H
      Harglo replied to the thread PISTON SIZE.
      Bill regarding hard soldering the cly an liner if you end up soldering first try a scrap pieces as the print calls for leading steel an...
    • H
      Harglo replied to the thread PISTON SIZE.
      Colin Re the lube using propane with the Snow. I put a small drip oiler on the intake side of the carb the inrush of the vapor seemed to...
    • H
      Harglo replied to the thread PISTON SIZE.
      Make sure going with the larger piston that there is enough clearence of the coolant holes which are very near the cly bore. An yes good...
    • H
      Brain Any thoughts on changing the pivot points of the gov arms? Harvey
  • Loading…
  • Loading…
Top