Grahn

Just call me the "Pulley King" of Carson Road. All my pulleys are finished except for the output from the clutch. One on the engine...

Some bits and bobs of Myfordboy's traction engine. Purchased the castings and drawings a couple of years ago and am finally making...

Returning with tail between legs ... A scope probe was capacitively coupled to the distributor's center lead to find out if the...

Im building Elmer's 46 Comber. In the process of laying out the cam per Elmer's instructions I found out how old Ive become as...

Gentlemen, Since I reported some of my health issues awhile back I thought that I should make a video of one of the two that I really...

In preparation for the flywheel retro-fit, the bell housing was removed from the engine while it was still on the display stand. The...

I just saw this “tube” video about a Kemp aircraft engine from around 1914 and it’s different atmospheric intake valves arrangement with...

A Holley carburetor is an impressive assemblage of 'kludges' (only from a fuel injection perspective, of course) that supplies fuel to...

For me the most interesting part of a build can be the steps taken to get a newly finished engine running. Too often it's done behind...

After settling on compromise locations for the voltage regulator and ignition modules, the engine and radiator were temporarily removed...

Okay!!! I've got my new knee!!! Went to hospital at 7:30 AM, got operated on at 10:00 AM, spent one night in hospital. Came home the...

In my builds I try to thoroughly test and fit each part as it's machined so final assembly can be assembly and not turn into a lot...

Hello hobby friends I would like to give you a short update on what has been going on with my hobby recently. The last few weeks/months...