You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
You might want to review the article in the HSM Steam and Stirling book V1 on a boiler/engine design for a 14 foot boat two teenage boys...
-
would you be able to share a photo or sketch. I found this youtube video by clickspring but he was mainly talking about an engraving...
-
Hi Jason.
Thanks for pointing that out.
If you were an engineering workshop you would expect to see each part fully dimensioned and not...
-
Hey All,
I'd like to share some information on a 3D printing filament that I believe can be used in place of foam for lost foam...
-
This is excellent. I have decades experience with lost wax and centrifugal casting and have evaluated Polymaker filament designed for...
-
Loading…
-
Loading…