Help Support Home Model Engine Machinist Forum:
-
-
Ccwalk replied to the thread Help with Arduino idexer.Hello Imre, This is the code which I used. Hope it is useful to you. Regards Colin /* 4x4 matrix keypad amd a 20 x 4 LCD. Edit...
-
Ccwalk replied to the thread Help with Arduino idexer.Thanks everyone for yor help. I finally stumbled on a way to correct the innaccuracy. This was by trial and lots of error. I tweaked the...
-
Ccwalk replied to the thread Help with Arduino idexer.Regards Colin.
-
Ccwalk replied to the thread Arduino Rotary Table for Dummies.Thank you all for your suggestions. I will try them out next time I am in my man cave. Limited time at the moment. I will post the...
-
Ccwalk replied to the thread Help with Arduino idexer.Thank tou Andrew for your reply. The setup is exactly as bmac2 describes in the article Rotary indexer for Dummies on this website. I...
-
Ccwalk replied to the thread Help with Arduino idexer.Thank you for your comments. I have checked the wiring, all good, and tried a different stepper motor. The results were exactly the...
-
Ccwalk replied to the thread Help with Arduino idexer.
-
Ccwalk replied to the thread Help with Arduino idexer.Thank you for your prompt reply, The stepper motor is controlled by the Arduino sketch, provided by bmac2 in Rotary table indexer for...
-
CI have recently completed the Arduino indexer for dummies . When I use it to do 360 degrees it is about 2 to 3 degrees short and this is...
-
-
Loading…
-
Loading…