Help Support Home Model Engine Machinist Forum:
C
ccolby
Member
- Joined
- Last seen
- Messages
- 17
- Reaction score
- 7
Latest activity Postings About
-
-
Cccolby replied to the thread The North Pole.I agree. I apologize for my narrow thinking up here on the 40th parallel. You're stuck with either using a Google Maps satellite image...
-
Cccolby replied to the thread The North Pole.Go outside on a sunny morning and drive a slender stake in a level area of ground. Make sure that the stake is long enough to cast a...
-
Cccolby replied to the thread The North Pole.LOL. Probably old, but still most excellent!
-
Cccolby replied to the thread Valve timing.The down sides of John Deere's famous 180-degree arrangement was "second order" side-to-side shaking of the tractor and that the second...
-
Cccolby replied to the thread Machining Valve Stems.You're welcome! If you're not familiar with George Luhr's astonishing craftsmanship, here is a link to his fully functional,1/8-inch...
-
Cccolby replied to the thread Machining Valve Stems.I agree completely with Longboy, here. Machine it with only one or two setups max to minimize run-out. I seem to recall that the late...
-
Cccolby replied to the thread How Do You Make Tiny Copper Washer Gaskets?.As previously suggested, grind the parting tool so the groove cuts through first on the washer side. Then I use a Noga hand-held...
-
-
Loading…
-
Loading…