Recent content by boxcarmj

Chuck, thanks for all the updates! Mike.

Chuck, are you still happy with your tool post? Would you change anything on it, I'm thinking of scaleing it up some. I do like the look of it very much. Thank-you! Mike.

http://www.lathes.co.uk/elffers/ Mike.

Hi, very nice! Also you can make a quarter plate marked with 90° mountit underneath (use a second pointer like the one shown). This would get you two angles at thesame time. Just a though! Mike.

Gus not to be a pest but here is one I just found, http://www.youtube.com/watch?v=QPwQf5l_FvU Mike.

Gus here are some links for you! http://www.youtube.com/watch?v=rNr-yQnpOGk&feature=uploademail http://www.youtube.com/watch?v=l4_Jt_SVYoI&feature=channel http://forum.weldingtipsandtricks.com/viewtopic.php?f=9&t=1417 http://www.weldingtipsandtricks.com/portable-bandsaw-stand.html Mike.

Hi! Is there a way to replace the pictures and then make this permenant, so we can all benefit from it. Thank-you Mike.

Hi! Is there a way to replace the pictures and then make this permenant, so we can all benefit from it. Thank-you Mike.

I just found this http://www.youtube.com/watch?feature=endscreen&NR=1&v=kB8LH_MOZcc and it says that there are no plans, but if you look at Modeltec Feb. 1998 you you will find an article with plans. Hope this help someone! Mike.

Try this web site, go to #10 there's a vise you can build. http://rick.sparber.org/ma.htm

Fast & Easy -- http://www.kbismarck.com/weights.html

Not old it is the current issue, www.modelenginebuilder.com. This is a great magazine, it is for IC builders and machininst alike (I have them all) enjoy! MIKE.

Hi! Have you seen page 15 of Engine Model Builder issue #24? This may do the job. MIKE.

GailInNM, these are the ones I want also. Thank-you MIKE.

Hi! I need some oilers to go into the end of ½'' shaft. Can anyone give me a link where to find them? Thank-you, MIKE.