Might I suggest that you buy a bit of nylon bar for your first turning adventures? It will allow you to see how the lathe and various tools function without danger of doing any damage to yourself, the lathe and of course the tooling?
Not very sure I understand how this works. Surely the tool needs setting to the centre of the chuck, not below centre which it looks like with this device.
Hi, I posted a reply to your question on making 2D drawings from 3D models under Software and Programming titled " Fusion 360 - Printing 2D Orthogonal Drawings" hope this helps as it's a step by step routine. Sorry it wasn't posted as a reply to you directly! regards, Barry
There has been a fair amount of discussion recently on how to produce printed copy from Fusion 360.
Hopefully the following will be of use to some -
Now this may not be the best/most efficient method for producing an isometric 2D drawing in Fusion 360 but it works for me!
With your 3D...