Recent content by azironwoiod

Advertise with us
Shop deals on ebay
Find deals on amazon
Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    8" Indexing/Rotary Table

    Hi Rick I sent you a PM. Thanks Jim
  2. A

    Re: First Engine No Plans.

    Thanks for the replies. I am using a metal lathe. I think Tin Falcon has me going in right direction. I was trying to think of some suction fixture and the two sided sticky tape I will try. I have the two plates turned down to 1/8. And, I have a 4 jaw, but, I couldn't think of a way it could be...
  3. A

    New Member and learer

    I am just starting to learn lathes. I am an accountant by training, but have always wanted to learn to run a lathe. Now I know I would like to learn a little about milling also. I have just started to turn some soft stuff like aluminum, a little mild metal. Very slowly. I don't feel good with...
See more
Back
Top