You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
It’s a good job you’ve chosen electric ignition Tony😃 with a compression like that you’d spend forever trying to hand start it with hot...
-
There’s been over 200 kits sold since 1990 but as to how many have been finished is unknown Tony.
Gardner were real innovators and...
-
Very nice Tony.
There’s a cracking video on YouTube, released yesterday of one of ours. Some nice close ups of the governor. Running on...
-
The problem, as you’ve already noticed is that eccentrics need a huge travel to find the bit that works. Needless to say you’ve pretty...
-
That’s pretty damn close Tony…. If you advance the half time gear by one tooth only you should get the exhaust to open just before BDC...
-
Good morning Tony. All the Gardner engines had an eccentric half time gear adjustment. The pin extended through the bed casting and was...
-
Some nice fabrication work there Tony. Our kit was based upon a 1911 size 0 engine so yes the proportions are going to be totally wrong...
-
Loading…
-
Loading…