You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
Finally got some quality time in the shop again. Back on my Twin Launch engine project. Like I have mentioned before, this type of...
-
I´m back in the shop again after a hectic period at work. Had some progress on the major part, the block. Have to say it was a scary...
-
Found out the block was a bit off so I skimmed a bit of it.:)
The plan is to make this scratch build look like the original with cast...
-
Fellow steamers: Greatly appreciate the discussion about “horsepower”. All good questions and points. Chapter 19 of “Model Stationary...
-
Main bearing plates pre-machined in a package, now mounted for line boring to bring to size and improve concentricity.
Had to stop the...
-
Loading…
-
Loading…