Search results

Elmer's complete book is public Domain and available at John-tom.com . Scroll way down towards the end. Lots of other good stuff there too.

Jack, The book calls to use neoprene faucet washers. I would like to send you some washers made from softer urethane. I will have my son waterjet 4 or 5 before you need them. We use this material in a forming operation and it lasts much longer than rubber. Make the steel washer ( on the left...

Have you Mastered the tube expansion yet? I may be able to help if not done yet. Bob

Looking at the picture on page 30 it looks as tho the piston rod E7 threads into E15. There should therefor be a tapped hole 10/32 centered in the back of E 15. Hope this helps. Have not studied the other problem yet. I'll look at it later. Bob

JC54, I to would like a set of plans. Is it possible for you to put them in the download section of this group?

The center point is not given. The radius appears to be tangent to the 5/32 radius and the 3/8 dia boss on the opposite side. Bob

I just ran across an original copy of the manual for this sharpener. Any interest?

I picked up a Microtek ScanMaker 5900 It has a built-in 4" X 5" film scanning. Downloaded ScanWizard from internet works great. Bob

I have a set of castings, Been under the bench for 30 years with a set of Wyvern drawings. Now when I got them out to start building obviously the castings are for a Briesch Associated and not the Wyvern. They look exactly like yours pictured. Now does anyone still sell these kits? What I need...