Search results

Looks good and it runs! That’s an Atta-boy in my book! Great job!

Beautiful engine and congratulations!

Wonderfully done ! Thirty years of not machining anything hasn't affected your abilities. Must be like a fine wine, only gets better with a little age! I can only hope the same applies to me but I'm already getting to my "advanced" years. Beautiful engine!

Brian, How about a small friction drive transmission. Small roller driving a disc, depending on which side of the axle the drive tire is on controls direction. Wouldn't take much to shift back and forth and the amount of travel also adjusts your speed. Further from the axle= lower gear ratio.

John, I've learned much from you although we've never met. Not just the machining end of things, but your patience is something to emulate. Best wishes and I'll have you in my prayers. Chris

Peter, phenomenal job on this engine! I've been reading through in awe. Chris

I'll be following this build, looks good so far!

I have no photos loaded to photobucket. I receive a block where a photo should be that says I need to upgrade my account, something about 3rd party sharing. I browsed thru and the first choice was insane. I love to look at the artistry you gentlemen preform, but that's a lot more than my...

Brian, don't think of your demand valve so much as a regulator for pressure of your gas, think in terms of scuba diving. The air from your tank only flows when you draw on it. It's known as a demand regulator also. It will only flow gas when it's asked. Propane forklift is the same way. More...

So far the biggest stroke I have done is 1 1/2", but then again, I'm just a noob.

She is a thing of beauty Brian! I'm curious as to the cadence she's going to have. I'm in the middle of a little bit and miss now, but I may just have a go a something similar. I'm not much for plans, kinda fly by the seat of my pants, but I'm always looking for interesting paths to wander down.

Very nice! I love the external plumbing