Search results

Update! As it turns out, the correct answer is M16 x 1.5 An interesting side note: Sieg eventually sent a reply to the inquiry I had made on their website, and they stated that the thread is M15 x 1.5... perhaps they lost a mm in translation or something? Has anybody ever seen an M15 x 1.5...

1hand, You need to set the scale resolution for each of the three scales. For the scales that came with my system, the correct setting is 1μm (1.00). I'd suggest that you reset the LINEAR ERROR COMPENSATION back to 0, and continue into the setup menu 'till you get to RESOULUTION. From...

I have tried searching everywhere and can't seem to find the answer. Hopefully, someone here can help me out. I'm planning the addition of a flood coolant system to my SX3 (Grizzley 0619), and I'm trying to find the thread size for the coolant drain hole on the back side of the table. I suspect...

I had pulled the table & saddle from my SX3 (after marking the locations for the X axis scale and the Y head bracket using a transfer punch and a combination of indicators, shims & clamps) and drilled the holes on my drill press. I did a partial re-assemble to locate and mark the locations for...

I've just completed mounting my "toolsales" DRO on my SX3, and I've got to say I am pretty impressed with the hardware! The installation instructions do leave a bit to be desired, but all we're machinists here and we should be able to figure out this mechanical stuff by ourselves, right? ;)...