Search results

Please Pardon my post. I had just finished with a tremendous amount of snow removal too. 90LX_Notch is definitely a fortunate individual to have a helpful neighbor. Thanks K Liv

I Like Kittens with Rice.

Agreed, do something else. Get off our butts' and head to the shop. If there it is anything worthwhile; it will be on TV or Yahoo news. K Liv

Clean and make everything you have work, then consider what must be done for either a return to working status or restoration. I usually go in between. I make everything work well and screw the paint. Chrome don't get you home. K Lively

What is all that White S**T. I don't want to see a Snow. K Liv

For converting Metric to decimal, Zero the caliper, select MM, open caliper to or measure desired piece in metric , press the MM/Inch button for an instant, very close conversion to decimal. K Lively

I didn't write this. I wish I were this clever KL Once upon a midnight dreary, while I porn surfed, weak and weary, Over many a strange and spurious site of 'hot XXX galore'. While I clicked my favorite bookmark, suddenly there came a warning, And my heart was filled with mourning, mourning for...

1/2 endmill in O-1, I would use 500 to 600 RPM. Conventional cut @ .050 DOC. Minimal spindle extension. Finish pass at same last number only climb mill. Use Oil, Slight drag on cross feed lock. KL

The Tip of the tool alone should contact the surface to be machined; either interior or exterior. Be especially careful for small Dia bores and OD's that the tip of the tool is on the Center Height. Bigger Dia's are more forgiving. Small Dia's, not so. Also address the tip of the tool w/ a Fine...

Hi Marv I appreciate the effort of Literary or Classical references in a good Feghoot or Shaggy Dog Story. There's just not that many out there. I also agree that Caesar should be "ferried" and not "grazed". Here's one for the Masses, myself included. I live near a small town and farming...

It seems like he is a tool collector. That's fine. Collectors are an essential part of the mix. They save and restore and keep things from hitting the scrapper. Support him highly; He's a tool lover. It's an accumulation and it gives him pleasure. Yes, a shop must have windows. Perhaps this is...

Not many people are aware of it, but Franz Liszt actually had a younger brother named Gary. He was quite the rebel and, unlike his older brother, who was an undisputed virtuoso of the piano, Gary Liszt chose to express himself in a style of music that approximates today's hip-hop. Unfortunately...

I Brake for bedframes. Great source of angle iron. Printers, yes. All water heaters spotted at the curbside get the brass fitting removed. A few weeks ago, a Twin cylinder cast iron Dayton Compressor, 3/4 HP motor , runs well. KL