Search results

Asking $1300 and my zip is 16145 i'm in PA

I have a grizzly 10x22 lathe for sale. Has QCTP some tooling and round stock. I made and installed the reverse gears,comes with a 4 jaw,3 jaw, follow rest, steady rest, a drill chuck.

Very nice job. Hope mine turns out half as nice .

I had the intention of banging out this build before Christmas, but have not been in shop for a month. I'm glad this has started a place were people can share there experience of working on this engine. I don't mind it being " hijacked ". Lol

Round stock drilled for crankshaft Crankshaft turned to size

I clamped front bearing plate in mill and cut first angle. Just eyed it up Then I measured rear height with a couple gauge blocks so I could flip over and repeat. It is pivoting on bearing shoulder .

Then I pressed one of the bronze bushings into front plate that I made but forgot to take a pic.

I then chucked up an old bronze hammer head and whittled out a couple crank bushings. [ATTACH]58697[/ATTACH

I first roughed out the base plate

In searching for a first engine to build I have downloaded, printed out, studied, and even started a few but have always hit a road block. The nicest are almost always in metric, to which i'm not yet equipped to drill, tap, etc. The most unique ones are above my ability at the moment or I just...

When you get to proj n met site read norman new guy. Its right in the center of the page.

Www.projectsinmetal.com

http://www.mini-lathe.com/Mini_lathe/Reviews/Reviews.htm

I'm 30 min north of that show.

Hi i'm from Sandy Lake,PA it's right along the PA/OH border smack dab half way between Erie and Pittsburgh