Search results

Hi Paul Sorry I did miss this post, all you need is water, washing soda a couple of bits of scrap metal some wire and a 12v battery charger. Eric's links above are the way to go it's very easy to do and harmless enough as long as basic safety guidelines are ad eared to. One of the posters in...

Put this on another forum I belong to but thought it may be of interest here also! Err, OK so I took a chance and bought an old KURT 6" vice and if you know anything about vices you'll know KURT are bloody expensive I could never justify buying a new one but this one came up on Ebay and I...

Thank you for all yours kind comments I am fairly new to engineering and to be honest a lot of your maths is baffling me I don't have a dividing head or a rotary table or DRO but I did make a disc for my indexer with 20 holes as suggested in a piece of laminate as a trial and although the holes...

Hi All recently got a spin indexer I realise roughly how to use it and how to split it into 360 degrees but I need to make a scale for my mill that's got 200 divisions 360 divided by 200 is 1.8 degrees, is this possible as I can't work it out... :confused:

Hi Jim I did have that problem a little when I first got it, it was second hand the old blade on it had a tendency to pop off now and again so I bought a new blade and it cured the problem. Hope this helps...

These are a few mods I've made to my saw for blade adjustment there are four allen screws on each guide I mill the slots a little deeper 5mm next is a mod to allow small pieces to be held and lastly a mod for holding a small vice all seem to work well and are well worth the effort, just thought...