I am happy. BUT I think I can make it better and I want to make it better. Im just in the process of reorganizing my little shop (11x22) along with setting up my cnc milling machine. Also trying to learn a new software to run it (Mach3). Along with juggling my family and work life. AHHHHH. Does...
Now that you mentioned that, It must be my video. Looks like everything is mirrored. Weird. Probably something I did wrong on my end recording the video. I had to have my 10 year old show me how to record a video on the IMAC. I had never done that before. I remember when I was a kid my dad...
Black85vette,
I got it together and running. Got it to run on lung power too! ;D
Im going to make some parts on my cnc mill when I get it all setup again. But for now this is as far as im going to go with it. I need to regroup and clean my shop, lathe etc..
Here is a movie. And thanks for all...
well i guess I should have done the card stock test first! >:( I measured with the crank screw hole close to the cylinder. It should have been the other way! :'( Oh well I need to make bushings and can still use the rod to get the bushing right. ::)
Ok this is what I did for the piston side to measure for the rod.
1. I dropped the piston to the bottom of the hole and measure with my digital caliper from the top of the hole to the bottom of the piston. I came up with .407
2. I then subtracted the .063 from the .407 and got .344
3. I then...
Hey Black85vette,
I have a question for ya. I am at the point where I need to make the rod for the piston. I already have made the rod for the valve. I am a little confused on how to measure for the piston rod. On the directions you said this.
"Do almost the same thing for the piston except...
Tail stock was a pain and I really wanted to make some mods to it. But I just lapped it in and kept fiddling around with the locking set screw ( got it to repeat every time when locked down). Got to with in 1/2 of thou. That is as good as I can get it with what it is. Took me 3 hours to get it...
Thanks!
I keep looking at the cylinders thinking, what can I do to make those look really nice. Not just square looking. Got a few ideas on dressing the frame up too. But before I go hog wild. I would like to see it run first. :big: