Recent content by Theclockworks

Where's the little chaps hard hat goggles and gloves :)

Had mine from Tesco cooking department £14.00 they say it's a chopping board but it's made of granite about 14x10 inch.

Yes it drilling a 16mm hole down a 49mm bar I've done all the turning I'am drilled to 13mm but can not get that last 3mm.

Had one never did leave the ground

How do I stop stainless steel work hardening?

Great work.

Hi David would be good to see how you attached the said motor.

had a problem with one of my DRO's ,I want to thank Ian from ARKEUROTRADE for his help ,first he rang back when they said he would wich a lot of company's don't do ,second after a two minute chat he is sending me a new unit out with out any quibbling true customers service. Thank you IAN. :)

One might want to take a look here. http://www.fastonline.org/CD3WD_40/CD3WD/INDEX.HTM Example http://www.fastonline.org/CD3WD_40/CD3WD/METALWRK/GTZ073AE/EN/B487_1.HTM

One word brilliant

I think you are getting a little carried away with the size of engine 1000cc single ? What bore and stroke are you thinking of ,I would say you would be saving yourself a lot of tears by sticking to say 500/600cc but that's just my humble opinion.

Hi Flylow Lost my mobilty about the same time as you,I'am as stubborn as a mule when it comes to getting things done,I realised early on that a large workshop was going to be a none starter so I opted for small machines sited indoors were I can stand or sit take a rest as needs be I also learned...

Could you not use silver steel

Another image

Had this kicking around in my toolbox for years,I believe it comes from the Raleigh works in Nottingham any ideas guy?