I have tried various concrete floor paints on my garage floor none of which lasted. I even followed all the recommended preparation of power washing before and after an acid wash. Finally came up with a cheap solution, I use Tremclad oil based machinery paint and cut it 25% with thinner. The...
I am in the market to buy an arbor for a cut off saw and future gear cutting blade for my mill. It appears that as usual there many options I.e. straight arbors that are held in a chuck or collet and R8 tapered arbors and specific hole size arbors and universal ones that will hold blades with...
Thanks for the KBC tip, I didn’t realize this tool supply company existed so close. Question now is, has anyone had experience with a 4” KBC Griplock milling vise? Apparently a Taiwan knock-off of a 4” Kurt at 50% of the price.
I am in the market for a milling vise. A Kurt appears to be the vise of choice but at a premium price. Is there an equivalent economical vice produced that has the same qualities as a Kurt, preferably a Canadian supplier?
Thanks for the detailed reply SHOPSHOE . Still don’t like the idea of drilling and tapping. Has anyone tried holding the scales on with JB Epoxy? A Canadian in Calgary.
I have a new Craftex CX600 mill/drill and would like to install a 3 axis DRO. A couple question:s;
1. Any recommendations on sourcing a suitable DRO.
2. I am baffled on how the scales are attached to the mill. Does this require drilling and tapping the mill frame or is is some other method of...
Brian, do you make the valve angle and the seat angle the same? If I remember correctly, there should be a couple of degrees difference so that there is a minimum contact point.
John