Recent content by RogerH

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Tips for Arduno software for Rotary Table Controllers

    That was quick, thanks very much for your reply, it does compile and load OK, but I have not yet got all the gear to test it for function. You did a brilliant job there, I wish I could understand even a couple percent of the coding. I will continue and hope the project works OK. Thanks once...
  2. R

    Tips for Arduno software for Rotary Table Controllers

    Hi all, Recently found this most useful project, well done to all involved, must have taken a whole lot of time and skill. I am a dummy on all this coding and have more trouble learning these days, ho hum. Thought I would give it a go, so after lots of problems, deleted the IDE from my PC and...
Back
Top