Recent content by richie garland

Thanks for all the advice...I managed to acquire a rotary table, made the cam housing fixture, and I remade the lifter block with a flat top....here is where I am a bit confused...should I center the rotary table, then center the jig on the RT, then center the lifter block on the jig; detach the...

Can you give me the correct trig formula? I do not have a rotary table.

I have milled the lifter block & preparing to drill the lifter holes. The plans give the location from the rear to the front for the holes but not from the side to the center. I know that it has to be at 23 & 29 degrees, but I am uncertain exactly where from side to center to drill. If anybody...