Recent content by Rich87Tx2
Help Support Home Model Engine Machinist Forum:
-
R
Hello from Harrison (Rockford), IL
Hello Herbiev! Made some good progress last night... Bought two new belts with no improvement. HOWEVER, in the process of changing them over i ran the motor without a belt and did felt a slight vibration. Further inspection revealed the drive pull on the motor is running .009" off center...- Rich87Tx2
- Post #3
- Forum: New Member Introductions
-
R
Hello from Harrison (Rockford), IL
Hello all! I'm looking for machinist friends local and otherwise. Also looking for parts for my machine. I have a 1992 Shoptask 1720 XMTC CNC "with plenty of mods" running Mach3. I'll try to get a photo posted. I have quite a bit of experience with the CNC lathe side of my machine but due to...- Rich87Tx2
- Thread
- Replies: 3
- Forum: New Member Introductions