Recent content by Powellkop

Hi hi its a ml7 long bed tri-leva basically my understanding of this is that with the levers there is no need for moving the belt to increase or decrease the speed I hope that helps and you are probably right about things being adjusted incorrectly but as far as I’m concerned I’m assuming that...

Hahahahah not a problem at all I never caught the typo myself but now I’ve read this myself and seen it in my post I’ve had a little laugh at myself and you are definitely as your name states awake hahaha

That’s going to be my next step I’m just not in a rush that’s all I will give it all a thorough check and clean as I go just as these bargains come along I have to jump on them

No problem at all mate and thanks

So Mike I ended up getting the backgear cluster for £80 and someone on a different forum has kindly given me the the gear assembly for the cost of the postage there’s been a few teeth damaged but but they have been repaired might need a little bit of finishing but I’m sure I can do that but it...

Welcome to the group Mark

Hi Mike this is what I think happened the previous owner was cutting thread carriage hits chuck hard gears somehow do a complete rotation stripping the teeth and then the machine is turned off just been on eBay and I can’t get hold of both of those gears new so I’ll have to get the dro first...

Thanks B

Thank you

I don’t even know enough to be dangerous yet but will be as so as I re-wire this thing and get the rest of the things done that I’m planning on lol

Thanks pat

Thanks Dave

Thanks for having me/putting up with me lol