Recent content by PaulG

http://www.homemodelenginemachinist.com/index.php?topic=8338.msg88744#msg88744

The Myford, might be a little slow for small work turning (pens). http://www.lathes.co.uk/myford/ Paul

Some 4" came up on ebay. http://cgi.ebay.com/15-4-1-8-OD-type-L-copper-pipe-/270684493031?pt=LH_DefaultDomain_0&hash=item3f060d94e7

George, I find it, at times on Ebay. This guy will sell as short as an 6" length for $45, but it is thick wall 3/8". http://cgi.ebay.com/COPPER-PIPE-TUBING-3-8-WALL-X-4-OD-X-1-LONG-/250464267555?pt=LH_DefaultDomain_0&hash=item3a50d56d23 Don't see this very often, to bad it's been messed...

$78 for the set. http://www.shars.com/products/view/4997/No_00_Precision_Keyway_Broach_Set

2X on too slow. Sounds like your doing production work. If so, you might consider purchasing a high speed drill press. I would be running a #29 around 1800rpm. On Aluminum 4000+.

http://www.harveytool.com/products/product_detail.php?product_id=12800&category_id=1&product_family=Ball+End+Mills

Check on Ebay, I bought some 3, 4, 6" from this Ebay vendor after the economy crashed. All metals are back up in price now. Shipping to Australia ??? http://cgi.ebay.com/6-Inch-Type-L-Copper-Pipe-Inch-/130442268667?pt=LH_DefaultDomain_0&hash=item1e5ef70ffb Paul

Use Promo Code NHEPR for 15% OFF & Promo Code MONDAY for Free Shipping*

Very nice for tight spots. This is with the lens off, so the camera can see it, very small.

Internal thread (to accept the threaded valve core) * Metric: 5.30 mm OD x 0.706 mm pitch * Imperial: 0.209 in OD x 36 tpi.

Student123, The print shows .2375 from crank disk center. Paul

Hi Chris, Maybe this will help http://www.baumhydraulics.com/calculators/belt_length.htm Paul

Chazz, will this work http://busybeetools.ca/cgi-bin/picture10?NTITEM=B2136MT3 Paul

Dean, Jeff & Kermit Thanks for your comments. Your both right. I flared both end at the same time with the bevels facing in, then reversed the nuts & rolled them flat. Paul