Recent content by Nut
Help Support Home Model Engine Machinist Forum:
-
N
First stirling build ... won't run.
Thank you. I'll concentrate on the flywheel/crank setup as it does not spin anywhere near as long as you expect.- Nut
- Post #3
- Forum: General Engine Discussion
-
N
First stirling build ... won't run.
I've just built my first Stirling based off the Grizzly H8101 plans. But I cannot get it to run. It spins smoothly and quietly. With conrods disconnected it spins for about 3 to 5 seconds. Pistons are a good fit. If I apply heat and spin it with the power piston disconnected that piston jumps up...- Nut
- Thread
- Replies: 2
- Forum: General Engine Discussion