Recent content by natalefr
Help Support Home Model Engine Machinist Forum:
-
-
-
-
Cnc - Manual router
What is the software ? Mach or other ?- natalefr
- Post #3
- Forum: CNC Machines & Conversions
-
-
Project of the Month - September 2018
Congratulations Gégé :D- natalefr
- Post #15
- Forum: Project Of The Month
-
Maudslay Model oscillating steam engine
Good job !- natalefr
- Post #4
- Forum: Engine Showcase - Finished Projects
-
-
-
Upshur Twin
And here we go :p Cylinders are made of solid cast iron yet to be finished, pistons adjusted without segments (after with use we will see) as on the Hupshur Horizontal Crankshaft of one piece- natalefr
- Thread
- Replies: 0
- Forum: A Work In Progress
-
Upshur Opposed Twin
Please send photos Good luck !- natalefr
- Post #6
- Forum: General Engine Discussion
-
Viton O-Rings
https://encyclopedia2.thefreedictionary.com/Fluoroelastomer I used FPM Viton This seal of FPM material can be used at temperatures ranging from -20 C to + 200 C. FPM seals are resistant to heat, aggressive mineral oils, atmospheric agents, petroleum products (hydrocarbons), aliphatic and... -
Upshur Opposed Twin
Ok I'm interested Don't forget hole for camshaft ;)- natalefr
- Post #4
- Forum: General Engine Discussion
-
Upshur Opposed Twin
If you build the crankcase in a block, how do you fit the crankshaft and camshaft inside? I suggest you put the bearings on the crankshaft and on the camshaft I'm starting this engine too :D- natalefr
- Post #2
- Forum: General Engine Discussion
-
A Brian Rupnow Air Motor
Nice engine ! :) Is a Brian Rupnow's petrol engine modified ?