Recent content by MarshSt

I located my g-code update (Curasettinjector.txt) for the Cura slicer 4.9.1. You add this at the end of the original "End Code" code and it will include all of the print profile settings to the end of your g-code post for each part you print. It's a couple hundred extra lines and I use WinMerge...

3D printers are good fun but can be frustrating at times. I also use the Cura slicer and have edited the post to add some additional code that helps with troubleshooting/ remembering which settings work. I will chase it down see if I can upload it. FYI: Don't let anyone put the cookie cutter in...

Chuck, Thanks for the reply and the info on the other sources. I will give them a try. SM

I'm searching for an old issue of Pop Mech, I think, that I remember reading at my grandfather's years ago that had plans for building a small running engine from wood. I think it used Ebony for the piston or crank and ran on 2-stroke mix. I'm guessing it was 50's era vintage. I originally...