Recent content by lowietje

try a gas sigaret lichter.it has a smale jet i used the gas filler cap to,to fill the gas container

The break is on the same disk as the drive belt is on. when the belt is tightenert the break belt is released as seen in the 2end video near the middel Lowie

Out 21.05 til 22.35 Amsterdam time

Welkom Paul Lowie

i did that some time ago the plans are good and compleat have a look at http://knutselhaas.hyves.nl/album/32624457/tram/UEApDQO9/

i use a old laptop for a dro http://www.lindsayengraving.com/other_interests/dro.html

I took a old refer compressor apart and its a good source of high quality cast iron

in some mouse balls are softsteel ball bearing balls to

I used the plans of Jan de Ridder and had to adapt it a bit. 1: a round tank gets a smaller surface as it uses petrol and the engine starts to run slower so i made it square. 2: the inlet regulator was to sensitive so i made a 3 way valve on witch i only adjust the 50% bigger air intake. in this...

Thanks all , yes it Will get a radio control in the coming weeks. and a doll to drive it. :D

Thanks but still a lot to do. this project is now almost a year on going but the last bits are taking the most time. The drive belt is hard to make in this scale to get it relay working. O rings have to big slip ,i am use a belt from a old printer now but it is a bit to long.

a Honda moped 6 v coil (very cheap and Small) a home made plug (see this forum) and http://hnm.110mb.com/i.html on a micro switch on the camshaft.

a beter video and a faster run on a hot summer day http://knutselhaas.hyves.nl/album/51845915/benz_d3/n8AzwKw-/video/1015722790/0/BMvr/

Thanks arnoldb still a lot to do but wen it is finest and reel running i Will post a better video

today a runner my model Benz d3 (a copy scale 5:1)from the drawings on this forum started after a throw or 2 have a view at http://knutselhaas.hyves.nl/album/51845915/benz_d3/n8AzwKw-/ to make i used some scrap stainless and normal steel,aluminium trespa for the wheel rims and 2mm welding rod...