Recent content by kd4gij

The small square head is just a pain to take collits in and out and get tight. I use my robo grip plires with the protector sleaves to hold the spindale.that and the larger nut alowes me to tightin the draw bar much tighter.

For the drawbar I had a peice of 1 1/16" hex bar laying around so I cur a 1/2" off and broached a squir hole in the cinter and used a setscrew to tighten it down. For the power feed I losened the right side endcap of the table and locked the table down and backed the lead screw out of the way...

I have had the 750 classic every scence sears started carring them. it worked fine right out of the box. came with 2 chucks and a fine wheel installed anda corse wheel. Never needed to try the corse wheel the fine has worked fine up to 3/4" bits. I only buy the cheaper jobber drills now a couple...

Dave I have a similar spot welder that was used for gold soldering Eye Glasses.

I have a Cameron drill press 164. I need to get the motor fixed. I got it out of the trash at work about 15 years ago the brushes where shot. I put in new ones and it ran for a few years. Now it throws a lot of sparks and no power.Took the motor to a couple of motor shops put thy won't touch...