Recent content by JaguarB

Now fitted pipe work and valves done its first extrusion

I have mine running using graphite lock powder see

Trying to post an image from http://www.boscott.co.uk/images/scalepress.jpg But its not showing ????? But see http://www.boscott.co.uk for the delay of the project

Work on the press continues But I have been distracted see http://www.boscott.co.uk

Second assembly of the 1:12 scale 1600T Fielding extrusion press trial assembly of the 1:12 scale 1600T Fielding extrusion press

First trial assembly of the 1:12 scale 1600T Fielding extrusion press

Good day in the workshop frames (16 inches long) pressure washed to remove flux, dried, sandblasted to remove rust and burnt on flux and finished then painted with red oxide

27-12-13 An easy bit to finish the evening "well it is Christmas" 1:12 Billet 0.5833 dia x 2.125 long

Main frame left and right backbone 16 inches long

billet ramp

News on 02-10-12 after some life changing events I have started on the press again Billet loader pivot See www.boscott.co.uk

19-06-11 The three tie bars 18" long 1" dia one with nuts fitted and their C spanner

To stop the crank turning on the crank shaft I set mime up then using a dremmel by hand drilled and fitted a 1/16 pin as like a key / key way this is captured by the end plate / washer yours Paul see http://www.boscott.co.uk/youtube.html

Made some more parts over the holiday Main ram and holder 5 pads and the control desk bracket Its a lot harder and takes more time than I first thought making my own model design and then scale drawings