I have bought some one piece needle bearings because they were cheap hoping I may be able to get away with splitting into 2 pieces with a dremel I’m looking into doing a small scale about the size of a model airplane engine so not sure if they would have split ones that size ?
Okay I may make a 2 cylinder seems heck of a lot easier but I’m curious why it needs to be sealed if both cylinders fire at same time on your model ? Also will the ring have a bit of bypass for oil so it’s not metal to metal on the crankcase
Looking to make a 3 cyl 2 stroke scaled down snowmobile engine design with a few questions!
- bearings? Will it get enough lubrication with a sleeve Or shall I try find a needle bearing small enough?
- new to machining just bought a small mill and metal lathe I have been on here for quite some...