You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
G
Today seen both cylinder heads drilled and tapped for the exhaust flanges, and both pistons were lapped into their cylinders. Cylinders...
-
G
Not a lot of clever stuff done today. I did drill the intake and exhaust ports in my cylinder heads that intersect with the valve cages...
-
G
Today was "little bits and pieces" day. I machined the four tappets, and between my shop and the main garage where my torches are, I...
-
G
After much fiddling and filing and clearancing the guard bolts into place and doesn't foul any of the gears inside the guard as they...