As for the strain relief, or cable glands - I couldn't agree more. Was my plan to put them in - but now I will wait until I can get it to run.
canadianhorsepower... thanks for the info, I will try some variations.
Thanks everyone!!!
Unfortunately, the wires coming into the box are labeled by myself. These labels correspond to the labels on the other end of the wires. only the connections on the bottom side of connection block are in question.
From the left, the 4 sets of wires are...
1) mains power coming in
2) wires...
Thanks "CanadianHorsepower".
In the photo of the electrical box, I am only concerned with the 4 sets of wires coming into the box (last photo) - they were all pulled out of the connector ends (with labels attached). So I used my best guess on the re-wiring, but no luck so far.
I have a CZ300 lathe from China and I am looking for some help in a wiring problem I have. During moving of the lathe, it tipped over and some wires were pulled out of the main electrical box. I do not know what order they are to be reconnected, so I am looking for someone to send or post...