Recent content by gjrepesh

Nice work!

I used a Sherline 4" rotary table. They are 72:1. Worked out quite well.

That looks like the same box I used for my rotary table. I found mine on eBay. This was my first project installing electronics into a box. I was surprised that I got all components to fit. Very pleased with the result. I'm thinking of doing a larger rotary table, thus a larger stepper, thus a...

So far, there is no mention of NAMES 2022 being canceled on their website.

If this gear is still a good fit on its shaft, I would consider cutting the keyway deeper into the gear and making a new key to fit.

Nice work! I like the fuel tank with the see thru end. What material is this?

I would like to buy or trade for Ammco shaper belt guards. The same were later used on the Delta metal shaper. [email protected] Thanks. Gary

dieselpilot, contacting Dumore worked out. They sent me a digital copy of the manual. I now have the info I need. Thank you for posting. Gary R.

I sent them an email. Will post the results.

Please contact me at [email protected] Thanks, Gary R.

I have a copy of the Dumore 44. Thanks for posting.

If would like to have a copy if possible...either PDF or physical copy. I would gladly reimburse. Let me know if this is possible. Appreciate the belt numbers. Gary R.

I have a Dumore 55-011 (series 8300) tool post grinder that is rather complete except for belts and a manual. Does anyone know the belt part numbers or has a copy of the manual that they can send me? Thanks. Gary R.

Dave, I finally got around to doing some followup work on the saw. Your post has been very helpful. I now have some good cutoff blade info. And I have some vise ideas since the original vise on mine is long gone and what was cobbled on is rather useless and will be replaced. Thanks. Gary R.

I bought this PRO-D-SAW which came without a vise. I have not found any info on this tool on the net. Does anyone recognize it? Would sure like to see a picture. Thanks. Gary R.