doc1955's latest activity

Help Support HMEM:

  • doc1955
    doc1955 reacted to Rotormac's post in the thread Precision Gauge Blocks with Like Like.
    It's a Bensen, really a flying chair. flew for the first time just before everything shut down last year so the only vid I have is...
  • doc1955
    doc1955 replied to the thread The great O ring discussion.
    When making 2 or 3 rings I use the method from the book "The Shop Wisdom Of Philip Duclos" This method has not failed me. When I make a...
    • Capture.JPG
  • doc1955
    doc1955 reacted to L98fiero's post in the thread Precision Gauge Blocks with Like Like.
    Here's a picture from the Wikipedia site, I have a similar but longer clamp and just use a couple of pieces of ground, square HSS for...
  • doc1955
    doc1955 reacted to Rotormac's post in the thread Precision Gauge Blocks with Like Like.
    Set up the required measurement with the slip gauges with an extra piece at each end protruding. The distance between the extras is the...
  • doc1955
    doc1955 replied to the thread endmill.
    Or a 4 jaw chuck or face plate and a lathe. ;)
  • doc1955
    doc1955 replied to the thread Precision Gauge Blocks.
    I have a set and use them quite often. They are nice to have when you need them I have some dial bore gauges and use them to set them up.
  • doc1955
    doc1955 reacted to stevehuckss396's post in the thread Chevy V8 Scale Engine Plane with Like Like.
    But just so you know doc built 2 of them.
  • doc1955
    doc1955 reacted to ajoeiam's post in the thread Press fit dimensions? with Like Like.
    Wasn't why I wrote what I did. I have been too often awed by work done by what most would consider amateurs or tyros but they worked...
  • doc1955
    doc1955 reacted to ajoeiam's post in the thread Press fit dimensions? with Like Like.
    Respectfully - - - - I would disagree!! I have been able to achieve a shaft precision of 0.0000"+0.0005"- on a lathe with an total...
  • doc1955
    doc1955 replied to the thread Press fit dimensions?.
    Proper press fit size depends on the dia size the bigger the dia the more interference you want as far as which causes the interference...
  • doc1955
    doc1955 replied to the thread Stirling helicopter.
    No blade are not necessary can be run with out. I have mine set up with the small hole in flywheel towards the tail with the power...
  • doc1955
    doc1955 replied to the thread Stirling helicopter.
    Excellent question I know mine tremble a bit when running but I never spent any time changing the position to see if it would help...
  • doc1955
    doc1955 reacted to gg89220's post in the thread Stirling helicopter with Like Like.
    hello a few more pieces
  • doc1955
    doc1955 replied to the thread Stirling helicopter.
    Looking good, I just finished 2. Hope your bevel gears are better that the ones I purchased. They were (looked like to me) 3d printed...
  • doc1955
    doc1955 replied to the thread V-twin ignition systems.
    Roy is a really good person to deal with and as mater fact I did the same thing run too much voltage. I started making my ignition...
Top