John,
I just need someone to give info on what I need to buy or modify. Do I need a variable power supply so I can adjust volts and amps and what specs on a controller. The controller I have is rated 12 - 40 volts 0 - 3 amps.
Thanks,
Bob
Thanks Bill
I'm using a 15 volt 20 watt transformer into a PWM controller. I've wondered if this was a problem because the drill motor seemed to have plenty of power when I used battery power before I mounted it to the mill. I guess I'm not to knowledgable(sp.) about this electronic stuff.
Bob
Thinking about building a power feed for my mill. Built one with a 14.4 DeWalt cordless drill motor but it is marginal on power. Does anyone know what size of a stepper motor would work. There are quite a few on Ebay but I'm not certain what size to buy and what controller to use with one if I...