lots of brass bronze all the brass screws special tools (endmills) little things that add up i doubled the blue prints now i know why they were so small that metal gets high... that fly wheel cost 90 bucks worth of brass i got some extra to make a pully for the other side but its not on the...
Its Rudy Kouhoupt Model Marine engine you can pick up a book with of prints for 5 engines he made for $20 on amazon. i double the size its about 12 in long 8 high an ways around 20lbs
i dont know when ill make another i only have 4 months left in tech school an i have to get a job i wont have a machine avalible to make more till i can buy my own
if you look close it his picture the crank is three parts the center an two journals in the middle being one part an the out sides with the lobe being the other they fit into a .200 pocket the same od with a .300 hole all the way threw so the lip on that pocket would be takeing most of the...
thanks for all the info he did try to clean the oil off and even burn it off he said nothing worked but i have just got some jb weld i think im going to try that next its cheaper then silver solder an flux anyone ever tryied that???
I have made my crank in 3 pieces I was going to silver solder it but I got oil on it an my instructor said in his experience if you get oil on it the silver solder wont stick ive tried red lock tight an epoxy nether will hold is there some type of acid or something that can get the oil off? My...
we called haas $30 bucks i hope it gets here soon that haas is my baby only me an one other guy can program it a use it all the manuals are being used an i want to get this engine done ive spent over 600 hours on it but i am a novice