Recent content by alexmillon

Skills are. And about the sizes and capacity I have counted all and have deduced. All to converge, but calculations yet haven't ended. I will be certainly glad for any help. Alex

I meant that size so as not to power

Dave Dimensions to be not large in such a capacity.Here are only about a gearbox http://www.youtube.com/watch?v=s-Y-BUtEtLc Even slightly smaller would be

Dave This engine for me so far that complicated.

I want most to make the engine from start to finish.To buy it it is simple.Especially more valuable experience.Especially since it's an invaluable experience.

The calculation found that if we increase the piston diameter to 44 mm and increase the stroke to 38 mm.It turns out 57cc engine size and power of 6.2 HP at 3200 RPM.It is for Webster engine.

I will look for the engine and take off with him all the same sizes.Or all of the same venture to upgrade the Webster engine until I need options.

Actually my question is who accept every detail of the measure and make a drawing Or can someone has measured the.

The only question is who to take these dimensions.Among my acquaintances there are none.

kcmillin Yes, you may be right about the hp.I would like to learn about it more.

Found the engine that I need http://www.youtube.com/watch?v=BiHHny9jlWM.Can anybody give any information on this engine (as created, etc.). Contact with the designer.

Jasonb And then title of the post.Your comment here is irrelevant. kf2qd Nobody was going to steal.Need a simple drawing of a low-power engine.A you said so as if I'm going there to do mass production.

Or can someone lying around Drawings V-Twin engine

Dave you reveal the essence of my question.'ll Get for the modernization and improvement of Webdter engine.Tomorrow will make all necessary calculations and next week want to use a build of my Webster's engine.

No, I want to be associated with models of engines.We pose the question in differently.I need a drawing of an engine with power from 4 to 6 hp.