I want to fit a pair of these 'spring type' leadscrew covers to my mini lathe, but I can't figure out how they're made, or where I could purchase them.
Or alternatively, the ideal solution seems if I could find something similar to dryer venting hose, which was a small diameter ~1"OD, I'd use that to cover the leadscrew.
Any ideas as to how this is made? My lathe thanks you in advance!
![Lead%20screw%20protecting%20cover.jpg](https://proxy.imagearchive.com/29c/29c8d23cabb61ee8a90424e135959d25.jpg)
Or alternatively, the ideal solution seems if I could find something similar to dryer venting hose, which was a small diameter ~1"OD, I'd use that to cover the leadscrew.
Any ideas as to how this is made? My lathe thanks you in advance!