olf20

And to end off the day in style, we have four valve guides machined and installed. This is going to be the first time I have built an...

I should have been working on the crankshaft but I had to do some casting to do for my partners grandson so I decided to try my intended...

Yes me too. I got the engine mounted on the base and added some rubber feet underneath. My hose clamps came in so I installed the fuel...

Progress on the Demon has been a bit slow, I have been working on a 3 cylinder radial as well, I will put a build log up about the...

Machining the top of the block Milling the bottom of the block

Hi I don't inject the silicone, I just fill the mould both side and the excess is squeezed out through the holes in one of the side plates

Here are some pics of how the mould works, basically It is how car builder has explained The 2 halve of the mould are filled and screwed...

Today has been a laid back kind of day. I made the oil filler tube and Loctited it into place, made the oil filler cap and right now it...

It has been a while since I posted a build thread here but thought I may as well show one. It all started when I said in another thread...

No machining over the weekend. This weekend was devoted to leaf raking. My one acre lot is surrounded on 2 sides by oak and maple trees...

Today I broke out my gear cutting stuff, and made gears for the Upshur. These gears actually fit inside the crankcase, but I stuck them...

Sid I listen to you on another forum. As long as it's about you, you seem to be a nice guy. But you seem to be a ankle biter, always...

What the hell is the matter with you guys? This is the reason why LOTS of great modelers machinists don't / won't post their stuff. If...

And this is how I got the 0.156" thick plate that the plans call for under the cylinders. I used 3/16" plate, and after everything was...

So, here we are. The parts to be soldered were heated up and coated with tinning paste. Then they were assembled in the correct...