Gordon

Brian: What sequence do you use when making a connecting rod with a removable cap? If you drill the crank journal hole before you split...

The plans were in "The Shop Wisdom of Phillip Duclos" https://secure.villagepress.com/store/items/detail/item/819 I no longer have the...

At this point you have two single cylinder engines mounted on a common base plate. You have separate carburetors, separate ignitions...

So were your cams near the correct position prior to setting them up with the rotary table? From everything that you have said before it...

Brian: You have a heat treat/pottery oven. Just put the parts in the oven and heat them to red hot and then lower the temperature slowly...

I am sure that the Canadian system has some problems but the US system has a lot of people not getting medical at all care because they...

I am not experienced enough to determine what is causing the problem but I set acceleration from 400 to 300 and reprinted a part which...

I went to the old computer and duplicated all of the settings from the old computer without going to the older Cura version on the new...

Recently I began having a problem with my "Y" axis slipping during printing. I have an ANET A8 printer and I am using Cura 5.6.0 slicer...

Welcome from another Michigander on the other end of the age spectrum.