Z power feed

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Jul 31, 2010
Messages
306
Reaction score
69
The next modification for my Jet JVM-830F is going to be a power feed on the knee. Even with this small mill it is the most I can do to crank the knee up. I will be installing a Servo power feed. I ordered a new M-2500-200. This is a basic kit with no adapters. I will be making what I need to install it.
0F373379-DD79-4088-9E29-410C267F5944.jpeg
 
The original shaft is 18mm. I have decided to cut it off and install an adapter shaft that I machined. The interface will be just over 1” and will be installed with 680 Loctite and once it is set I will install a 1/4” split pin.
 

Attachments

  • 928DAD63-4379-4426-A5BC-7CF44D033969.jpeg
    928DAD63-4379-4426-A5BC-7CF44D033969.jpeg
    1.4 MB · Views: 0
  • F84ED8BD-863C-4CDB-AD76-9E5C7F03752D.jpeg
    F84ED8BD-863C-4CDB-AD76-9E5C7F03752D.jpeg
    1.4 MB · Views: 0

Latest posts

Back
Top