Steve_Withnell
Well-Known Member
- Joined
- Sep 29, 2009
- Messages
- 50
- Reaction score
- 3
Quite a long time since I progressed the Stuart Victoria, over the weekend I've been able to crack and get the governor assembly completed. The whole build is documented at my blog:
http://stevewithnell.wordpress.com/
That link will get you to the blog. Because it's a blog its very much last in first out! Hopefully there is something of interest here, have a browse, see what you think.
A couple of video's on Youtube if you haven't seen them -
[ame]http://www.youtube.com/watch?v=553i48WkJts[/ame]
this is a trial run of the base engine, but you can see the double height steam chest to accommodate a Meyer expansion valve arrangement.
Here is the engine developed with the drive gear for the Meyer expansion valve:
[ame]http://www.youtube.com/watch?v=Kzk8EwN7-34&feature=related[/ame]
In any event, searching on youtube for "swithnell" will get you the metalworking videos I've posted to date.
Hopefully something of interest for you!
Best Regards
Steve
http://stevewithnell.wordpress.com/
That link will get you to the blog. Because it's a blog its very much last in first out! Hopefully there is something of interest here, have a browse, see what you think.
A couple of video's on Youtube if you haven't seen them -
[ame]http://www.youtube.com/watch?v=553i48WkJts[/ame]
this is a trial run of the base engine, but you can see the double height steam chest to accommodate a Meyer expansion valve arrangement.
Here is the engine developed with the drive gear for the Meyer expansion valve:
[ame]http://www.youtube.com/watch?v=Kzk8EwN7-34&feature=related[/ame]
In any event, searching on youtube for "swithnell" will get you the metalworking videos I've posted to date.
Hopefully something of interest for you!
Best Regards
Steve