ksor
Well-Known Member
- Joined
- Jul 18, 2007
- Messages
- 188
- Reaction score
- 14
I'm trying to make an "electronic" round table with a step motor controlled from a C# program in a pc.
Should I have some "feed back" from the table to be sure it has turned what the program exspects
OR
should I just have a very strong step motor without "feed back" ?
Best regards
KSor, Denmark
???
Should I have some "feed back" from the table to be sure it has turned what the program exspects
OR
should I just have a very strong step motor without "feed back" ?
Best regards
KSor, Denmark
???