Spark plug connector

Discussion in 'General Engine Discussion' started by Gordon, Jan 25, 2020.

Help Support HMEM by donating:

  1. Jan 25, 2020 #1

    Gordon

    Gordon

    Gordon

    Well-Known Member

    Joined:
    Jan 4, 2011
    Messages:
    651
    Likes Received:
    90
    Has anyone found a source for a spade connector for CM 6 spark plugs. There are hundreds of connectors made for wire termination which are only a few cents per piece but I have not found one which fits the CM 6 plug. S&S offers a connector but at $2.50 each they get a little expensive and every time I need one I have just used the last one.
     
  2. Jan 25, 2020 #2

    Brian Rupnow

    Brian Rupnow

    Brian Rupnow

    Well-Known Member Project of the Month Winner

    Joined:
    May 23, 2008
    Messages:
    11,899
    Likes Received:
    4,441
    Gordon--On one of the threads I post on, there is an excellent tutorial on casting your own sparkplug connectors/boots from silicone. It is a very simple 'reverse image' machined into two steel blocks. I will try and find the link and post it here. I think that it was originally posted by Gail in New Mexico.--Hah!!! Found it. Photosuckit has blurred the pictures but you can still read the text and get the idea.---Brian
    https://www.homemodelenginemachinist.com/threads/ignition-boot-molding.14539/
     
    Last edited: Jan 26, 2020

Draft saved Draft deleted

Share This Page

Group Builder